All work
Medical devices · Breast imaging

iSono Health ATUSA

A wearable 3D breast ultrasound that scans the whole breast by itself in about two minutes, cleared by the FDA in 2022.

Years
2016–present
FDA
510(k) cleared, May 2022
Scan
Whole breast, 3D, about two minutes
Patents
US 12,156,763 · EP 3432804 (co-inventor)
Disciplines
Mechanical, Medical devices, Manufacturing, Electronics

The product

ATUSA is a compact, automated whole-breast ultrasound with a wearable accessory. The patient wears a cup that fits her; the scanner docks into it and moves the transducer over the whole breast on its own, building a 3D volume for a clinician to read. The FDA cleared it in May 2022, and iSono calls it the world's first automated, wearable 3D breast ultrasound.

A scanner that drives itself

Inside a sealed puck, two motors move the transducer: one carries it all the way around, the other sweeps it through an arc. Both drive small pinions on molded racks, so the gear teeth had to be right. We worked through 8-, 10- and 12-tooth pinions and profile shift until the mechanism ran without binding, then milled fixtures to rework parts in the shop instead of by hand.

Sealed, because it works in water

Ultrasound couples to the skin through water, so the scanner sits in it. Every way in had to be sealed: motor shafts, cables, connectors and the lid. We built the vacuum and pressure test rigs, chased leaks one connector at a time, and designed the potting, glue fixtures and tests that made the seals repeatable in production.

One cup, many sizes

People come in all sizes, so the cup is a bellows on a lifter, made in several sizes, with flexure petals and snap latches that hold it at any height. The lifter and latches went through dozens of 3D-printed versions in our shop before they went to injection molding.

To production, and the next generation

We worked alongside iSono's team and their contract manufacturer on critical dimensions, inspection documents, assembly fixtures, end-of-line testers and design-for-manufacturing reviews of the molded parts, plus the charger dock. Since 2025 we have also designed electronics for the next generation: the board stack in the puck, its folded flex circuits, and the bring-up of the first units.

What we did

  • Mechanical design of the scanner and cup, from the 2016 prototypes through injection molding; Chris is a named inventor on the patents.
  • The transducer drive: motors, pinions and racks, and the gear design that made it run smoothly.
  • Waterproofing, with the leak, vacuum and pressure test rigs to prove it.
  • Fixtures, testers and inspection documents for production.
  • Electronics for the next generation: boards, flex circuits, bring-up and firmware fixes.