Cryogenic optics lab
Stages, mounts and wiring for optics experiments in high vacuum, a few degrees above absolute zero.
- Years
- 2022–present
- Environment
- High vacuum, 4 K and millikelvin
- Position sensing
- Capacitive, nanometer scale
- Disciplines
- Mechanical, Electronics, Firmware, Cryogenics
The experiment
An optical cavity traps light between two mirrors. Here one mirror is the polished end of an optical fiber, and the other sits microns away on a sample. The two have to be brought together, aligned and held still, then sealed in a vacuum can and cooled in a dilution refrigerator, where no one can reach in to adjust them.
A stage that knows where it is
The first job was a Z-stage for the lab's microscope: piezo micrometers under a kinematic top plate, with formed-wire springs to hold the glass. To see how far the stage had really moved, we put capacitive position sensors in its base plate, four differential channels read by an RP2040, with firmware that turns each reading into distance from first principles.
We took apart the commercial piezo driver to learn how it works, then built our own boost-converter driver to make the sawtooth waveforms the micrometers need.
Built for the cold
Parts that go into a fridge are copper and titanium, and every one of them has to survive the trip from room temperature to a few millikelvin and back. We designed fiber and lens holders, copper sample stands, and a cold sample holder that drops onto a kinematic mount and makes its electrical connections through pogo pins, with its own heater and temperature sensor. Most designs started as 3D prints in our shop before they were machined.
Wiring the fridge
Signals have to reach the experiment through every stage of the fridge without carrying heat down with them. We designed the cryogenic flex circuits, micro-connector adapter boards and temperature sensor boards inside, the rack panels and cabling outside, and then high-density connections for the lab's 4 K and millikelvin fridges.
What we did
- A piezo Z-stage with built-in capacitive position sensing, and its firmware.
- A custom piezo micrometer driver.
- Fiber, lens and sample holders for the cavity, from 3D-printed prototypes to machined copper and titanium.
- Cold sample holders with kinematic mounts, pogo-pin connections, heaters and temperature sensors.
- Cryogenic flex PCBs, connector adapter boards and rack panels for the fridges.